12 V DC LED lights!

Reduce by 90% the electricity you use to run ship’s lights and off-the-grid accommodations

Save fuel or gas by depending less on generators and other charging devices!

Save wear and tear on those generators and reduce the noise!

Great for small Resorts on remote islands!

A small company in Fiji is making great white LED lights!

Those LED use 10% of equivalent incandescent lights!

They are submersion tested to 1m deep! So no worry about their being waterproof

Full brightness with battery voltage between 11-16 V DC!

The only LED lights we know that are backed by a Lifetime Warranty

Designed and manufactured by cruising sailors!

We carry several models but here are our most popular 3 models: each light consists of a PVC cap with LED, 250mm fully tinned wire pigtail … you mount it any way you like! (See some examples below) We have marine lights (anchor, running, steaming, cockpit, nightvision, ...) and we carry pathways and emergency lights for resorts.

*Marker Light 15 LED - Owl*	*Room Light 18 LED - BEKA*	*Spot Light 9 LED - Doe*
Uses less than 0.090 amps!	Uses less than 0.100 amps!	Uses less than 0.060 amps!
Vertical light cone angle = 30 deg	Vertical light cone angle = 30 deg	Vertical light cone angle = 30 deg
Example of application	Example of application	Example of application
Only Euros 32	Only Euros 36	Only Euros 16

We specialize in designing systems for island resorts and retrofitting existing 12vdc halogen light fixtures. Contact us with your requirements. For info and ordering, contact us via email lucseawalker@gmail.com

Excerpts of The Bebi Philosophy (manufacturer)

Bebi ultrabright white waterproof LED Light Assemblies have been engineered and tested in the Samoan, Tongan, and Fiji Islands by experienced (20 years) cruising sailors and have been tested over the course of the last four years on a variety of boats. By using tinned pigtail leads, they can be used with impunity in the elements instead of trying to rely on the improbability of waterproofing an automotive socket. Because of this, and their inherent LED technology, they are also a good choice for a powerboat, which will often loose an incandescent navigation light when a cold wave hits.

To prevent lights failure, the LED's within our light assemblies have been electrically matched and incorporate a current regulator circuit. Most LED's lights designed for either the automotive or decorative lighting market rely on a simple dropping resistor in their circuit, with the assumption that they will be used over a small voltage range. In marine and off-grid applications, LED lights see a far greater voltage range. As a consequence, either the dropping resistor has to be sized for the greatest possible voltage, with an attendant and linear decrease in light as the voltage drops into the "normal" discharging voltage level (12.25-12.75 volts), or the lifetime of the light unit is reduced. Our testing has shown that a resistor that is sized for a 12.75 volt supply will lead to a module failure within 4 years! Not only do our lights contain a regulator circuit, but LED's have a very wide range of performance values. All of the LED's within our light assemblies have been 100% tested AND matched for even greater improved reliability.

With our rigorous testing and a current regulator circuit, we feel confident in offering a LIFETIME replacement for our lights, with the proviso that they not be subjected to greater than 16 volts DC (32 volts for the Namu and Bebe).

Check the manufacturer website directly for more details ! http://www.bebi-electronics.com/

Uses less than 0.090 amps!

Uses less than 0.100 amps!

Uses less than 0.060 amps!

Only Euros 32

Only Euros 36

Only Euros 16